I managed to get down the garage for a quick session on Saturday afternoon. I was planning to cut out the passenger side floor pan. However, this seemed more difficult than I remember the drivers side being for some reason and I had soon snapped all of my metal cutting blades (despite having picked up a couple of new ones from the tool shop on the way over!). I managed to get about half way round the floor pan, so at least I don’t have too far to go next time:
Next I decided to turn my attention to removing the old tar board and seam sealer from the tunnel. I found using a fat chisel with wooden mallet to be an effective method and it would usually chip off in big chunks. Any residual tar could be taken off by gently scraping with the chisel held at a shallow angle:
What a satisfying mess:
So, not the most productive of weekends, but it sure felt good make a little headway after so long!
Ugh I feel ya! chipping away tar board is miserable.
ReplyDelete